Home > News > Content

The Molding Machine Improves The Density Of The Material

The working principle of the molding machine is similar to that of the injector, which is the injection of a plasticized molten state (ie, viscous) into the closed cavity by means of the thrust of the screw (or plunger) The process of obtaining the finished product after curing. Injection molding is a cycle of the process, each cycle mainly include: quantitative feeding - melt plasticization - pressure injection - filling mold cooling - Kaiqi pickup. Forming Machine Remove the plastic parts and then closed the mold, the next cycle.

Forming machine features

(1) molding machine computer using imported PLC computer host chip, matching LCD screen, software backup fault self-diagnosis system and error correction function, Forming Machine the operation more convenient, the control program to fool-style design, no professional training can be post operation The

(2) molding machine full hydraulic drive, with the first domestic stepless hydraulic FM technology to solve the molding machine on a variety of materials and block type of fitness, Forming Machine improve the material density, shorten the molding cycle.

How to use the molding machine

1, select the flattening table, a steady machine, you can pull the chassis feet to facilitate the observation of the machine panel. The same time as

2, will be hand-held sensor head plug into the panel of the socket and tighten. The same time as

3, plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use single-phase three-wire power supply. The same time as

4. Open the "POWER SW." On the rear panel of the chassis, Forming Machine press the "SWITCHING" button on the panel, and the "Ready" (WARM UP) "green indicator will light and the machine will work. The same time as

5. Press and hold the "SETTING BUTTON" key to set the appropriate value, usually between 0.5 and 2.0 seconds. The same time as

6, the sensor head on the container cover, press the handle on the start button, then "HEATING" red indicator light, that is heating, the sensor head do not remove, "HEATING" red light And then remove the sensor head, Forming Machine and so on "WARM UP" green light or the machine buzzer short "beep" prompts and then the next container can be sealed. The same time as

7, check the sealing quality, according to different materials, diameter containers and production efficiency, appropriate dressing "set button (SETTING BUTTON) button, making the best quality sealing.