Home > News > Content

The Molding Machine Makes The Operation Convenient


The working principle of the molding machine is similar to that of syringes, it is the push of the screw (or plunger), the plastic injection of the melted state (that is, the viscous flow state) into the closed mold cavity, the process of obtaining the products after solidification and shaping.

Injection molding is a cycle of the process, each cycle mainly include: quantitative feeding-melt plasticizing-pressure injection-mold cooling-starting die pickup. Forming Machine Remove the plastic and then close the mold, the next cycle.

Molding machine Features

⑴, molding machine computer using imported PLC computer host chip, matching LCD display, software standby fault self-diagnosis system and error correction function, make the operation more convenient, its control program with a fool-style design, no need for professional training can be the operation.

⑵, forming machine full hydraulic drive, with the domestic first STEPLESS hydraulic FM technology, Forming Machine to solve the molding machine for a variety of materials and block-type adaptability, improve the material compactness, shorten the molding cycle.

How to use the molding machine

⒈ Choose Flat table, stabilize the machine, you can open the chassis feet to make the machine panel easy to observe.

⒉ the plug on the hand-held sensor head into the socket on the panel and tighten. Attention to the location gap ·

⒊ plug one end of the power cord into the socket on the back panel of the chassis, Forming Machine and the other end into the power supply socket, make sure to use single-phase three-wire power supply.

⒋ Open the chassis back panel, "Power SW.", press the Panel "power Switch (switching)" key, to "prepare (WARM up)" Green LED light, the machine can work.

⒌ hold the "Set button (SETTING button)" Key, set to the appropriate value, typically between 0.5-2 seconds.

⒍ put the sensor head over the lid of the container, click on the Start button on the handle, then "heating (heating)" Red indicator light, indicating that is heating, the induction head do not remove, "heating (heating)" Red led off and then remove the sensor head, etc. "Ready (WARM up)" Green indicator light or the inside of the buzzer short sound "beep" prompts can also be the next container sealing operations.

⒎ Check the sealing quality, according to different materials, Forming Machine diameter of the container and production efficiency, appropriate trimming "set button (SETTING button) key, making the best sealing quality.